Jul 24th, 2008, 8:05pm
   FabulaTech Forum
   Serial Port Solution
   Virtual Serial Port Kit (Moderator: Andrew)
   Break Line simulation?		 « Previous topic | Next topic »
Pages: 1  Reply Reply Notify of replies Notify of replies Print Print
   Author  Topic: Break Line simulation?  (Read 874 times)
lmpombo
FabulaTech Forum Newbie
*





   
View Profile Email

Posts: 2
Break Line simulation?
« on: Mar 26th, 2007, 1:27am »		 Quote Quote Modify Modify
Hi everyone,
 
   I really like this software. I was trying to debug a serial communication program I made and used to test it. Everything was good until I had to test timeouts by simulating a line break or cable removal. Is it possible to do this with this program? I have searched everywhere but could not do it.  
I like this program best because it is better in terms of pin parameters.
Please tell me if it is possible to simulate line breaks with this.
 
Thank you very much.
Kind regards,
 
lmpombo
IP Logged
Andrew
FabulaTech Forum Moderator
FabulaTech Forum Senior Member
*****






   
View Profile WWW

Gender: male
 Posts: 422
Re: Break Line simulation?
« Reply #1 on: Mar 26th, 2007, 1:46am »		 Quote Quote Modify Modify
Hi,
Thank you for your interest in our software and for good words about it. Unfortunately there is no feature that emulates line breaking. May be you could test timeouts on one side by closing application on another side?
Thank you.
IP Logged
Andrew Scott

FabulaTech
===================
http://www.fabulatech.com
lmpombo
FabulaTech Forum Newbie
*





   
View Profile Email

Posts: 2
Re: Break Line simulation?
« Reply #2 on: Mar 26th, 2007, 9:52am »		 Quote Quote Modify Modify
Well, I did that for the timeout tests already. But the problem is I have to test something like breaking the line and then bring it back up so that I can test the resume transfer functions.
 
Any ideas?
 
Thank you very much.
 
Kind regards,
 
lmpombo
« Last Edit: Mar 26th, 2007, 9:53am by lmpombo » IP Logged
Pages: 1  Reply Reply Notify of replies Notify of replies Print Print

« Previous topic | Next topic »